I want to make a corner "cabinet" (no doors..basically a platform) out of 2"x10" wood with the wood going vertically. I won't go into why I am using 2"x10"s vs. building a real frame and applying wood.
I attached a sketch when looking from the top of the "frame" (the whole thing is really solid vertical 2x10s).
My question is, how do I figure out the angle, cut and attach the lower right corner?
I have a table saw (that can do angles) and compound mitre saw and little woodworking experience. I want to keep it as simple as possible (no biscuits, dovetails, pocket joints).
I assume I need to calculate the angle and set my table saw. I am not sure if I can screw those pieces together themselves or need another interior angled piece of wood to join the corners.
Neatness/strength are not extremely critical to this project.
I attached a sketch when looking from the top of the "frame" (the whole thing is really solid vertical 2x10s).
My question is, how do I figure out the angle, cut and attach the lower right corner?
I have a table saw (that can do angles) and compound mitre saw and little woodworking experience. I want to keep it as simple as possible (no biscuits, dovetails, pocket joints).
I assume I need to calculate the angle and set my table saw. I am not sure if I can screw those pieces together themselves or need another interior angled piece of wood to join the corners.
Neatness/strength are not extremely critical to this project.
Walang komento:
Mag-post ng isang Komento